In the MODELS book, it says that these values are specified in pu (base). I am confused whether this means the system base or the generator MVA base.
Looking forward to learning the correct answer.
The values are in generator MVA base.
Does these models have any default parameters for like Kp or Ki wich represent PI control proportional and integral gains ? If yes, where is it ? I investigated through PAG1 and PAG2 and found nothing about it.
Kp & Ki parameter is available in REPCA1 ,J+1 , J+2. You can tune it as per your requirement
Asked: 2019-06-12 17:43:37 -0500
Seen: 563 times
Last updated: May 19 '20
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
