1 phase opened fault in PSS/E
Hello, Can I simulate 1 phase opened fault in PSS/E? I mean just one side of a specific phase has been opened. Thanks.
First time here? We are a friendly community of Power Systems Engineers. Check out the FAQ!
Hello, Can I simulate 1 phase opened fault in PSS/E? I mean just one side of a specific phase has been opened. Thanks.
Yes, you can do that for branches without susceptance, i.e. B=0. First you have to take the branch out of service. Use SCMU - 2 phases closed - and enter the impedance of the branch, see picture below and POM 10.4.2.
Here I have first taken the existing branch between bus 3001 and 3003 in savnw.sav out of service.
Asked: 2017-12-15 05:55:00 -0500
Seen: 3,735 times
Last updated: Dec 17 '17
Equivalent two-phase to ground fault admittances at Transmission nodes
Exporting PV curve data from PSS/E to excel
IEEE system bus data with sequence data for unbalanced fault
Voltage Spike after deep fault
How to solve this problem of wind generator
CMLDxxU2 and CMLDxxDGU2 modeling
PSSE crash after trying to install some python libraries
When i run ASCC fault calculation PSS/e crash down and restart without any results