Hi folks, when I do unbalanced fault simulation such as 1 phase fault and so on in PSSE ,It was failed to add fault,who can help me how to do it,thank you
hello I thanks that your simulation model is wrong (verify if you have the sequence data).
As shown in the figure,i don't have the sequence data
If you do not have any information on the sequence impedance, it would be impossible to determine.
If you do have the Thevenin sequence impedance at the particular bus you are applying a fault (and let's say not for anywhere else in the network), you can emulate a bolted single-phase fault by setting the impedance value to the sum of the negative and zero sequence components of the Thevenin impedance, and apply a three-phase fault.
Comments
Make sure you have sequence data.
Your are right ! Because i a beginner so there not have the sequence data