First time here? We are a friendly community of Power Systems Engineers. Check out the FAQ!
Model WT3P1 Bus 101 [WIND] Machine "1 " : When WT operates at partial output, initial condition suspect may be reported for STATE(K+2). No action is needed
Above error was tried to solve by changing WT3E1 parameters. Kindly guide how it can be resolve....
Model WT3P1 will report initial condition suspect whenever initial generation Pgen/Mbase (pu machine base) is lower than PMX. The integrator, STATE(K+2), will be initialised to 0 while the input signal is negative. Hence, there will be initial condition suspect reported, which can be ignored.
This is not an error and it is not possible to correct it by changing WT3E1 parameters
Asked: Aug 29 '3
Seen: 511 times
Last updated: Sep 01 '23
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
