Hello, i am currently working in IEEE14 bus system and i added a wind turbine in order to study the transient stability. I inserted the wind turbine WT3G2 model and when i do a simulation i see the voltage of the wind turbine starting from 0.4 pu instead of 1 pu that it should have. Does anyone know why and what should i do?
Check the post "Renewable Plant Modeling - Solar PV - Wind". Example uses SAVNW case with type-4 wind plant.
The WT3G2 has been deemed obsolete and replace by the renewable models, 2nd generation (modeling using REGCAU1 family of models).
I did like you said but i have a new problem. When i do a simply dynamix simulation the voltage in wind turbine is not stable and the voltage in other buses rise a little and then become stable .These are my files. https://drive.google.com/drive/folders/14ao4Q3qYGXBgIG69jdA7A6oz8gymu25I?usp=sharing%3C/p%3E (https://drive.google.com/drive/folders/14ao4Q3qYGXBgIG69jdA7A6oz8gymu25I?usp=sharing)
Mr Conto i found what the problem was. When i did power flow->solve it sai that Pgen was minus. After decreasing the wt from 100MW to 50MW, in the no-disturbance run everything is stable. Thank you for everything
Mr Conto, i run a dynamic simulation for the power system with an unbalanced fault. The system always stabilizes after the fault , even if the fault duration is over 5 sec. Is it normal? Shouldn't it have not after a big fault duration?
Asked: 2019-12-13 11:21:44 -0500
Seen: 512 times
Last updated: Dec 13 '19
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
