CLOD model in PSS/E
Hello, I need default parameters of large motor and small motor in the CLOD model. Could you guide me? Thanks.
First time here? We are a friendly community of Power Systems Engineers. Check out the FAQ!
Hello, I need default parameters of large motor and small motor in the CLOD model. Could you guide me? Thanks.
The modelling of large and small motors in CLOD model is described in Program Application Guide, Volume II, Chapter 21.2.3 (rev 33).
Asked: 2017-11-09 01:25:08 -0500
Seen: 808 times
Last updated: Nov 10 '17
Capture keyboard interrupt in PSS/E script?
CMLDxxU2 and CMLDxxDGU2 modeling
when the rotor angle becomes negative in PSSE, what does it mean?
PSSE crash after trying to install some python libraries
Equivalent two-phase to ground fault admittances at Transmission nodes
Import psspy returns error: DLL load failed
There are no default parameters, but I assume you mean typical parameters. It depends greatly on what system you are modelling, e.g. the amount of AC load or industrial load.
The internal parameters of large motor and small motor aren't adjustable in the CLOD model so this model should have default parameters.
I thought you meant the percentage of small and large motors. See my answer regarding the motor parameters.
Thanks a lot.