Hello everyone, I want to do a simulation from 2 seconds until 10 seconds. but the code for running the model is psspy.run(option, tpause, nprt, nplt,crtplt) and it has only the end time. Does anybody know how to define the tstart for simulation? Thank you.
Hi, not sure if my answer is accurate, but is this for the dynamic simulations? Because if so, as stated above, PSSE will run to the end time that is set up. All you have to do is when it reaches its end time is to change/extend the run time. As for getting the results from 2-10 seconds, have you tried changing the x values of the output graphs? Or is that not possible?
After initialisation the time is at minus two time steps. Every call of RUN simulates up to the next pause.
Please read the manual!
Asked: 2020-02-10 13:30:18 -0500
Seen: 820 times
Last updated: Feb 14 '20
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
