how do i model a motor load in PSSE ver33?
because three phase short circuitcontribution for motor is 6 times. so can i say i just put in a simple load which require to key in Pload and Qload?
First time here? We are a friendly community of Power Systems Engineers. Check out the FAQ!
because three phase short circuitcontribution for motor is 6 times. so can i say i just put in a simple load which require to key in Pload and Qload?
Asked: 2019-10-03 12:12:18 -0600
Seen: 254 times
Last updated: Oct 03 '19
Breaker contact parting time in IEC 60909 fault calculation
How do I change the loads on PSSE?
Change all buses load P and Q injections
How to start an induction motor during the running of simulation of a model?
AREA/ZONE/OWNER based Load flow Report
How does IMD Model Parameters work?
while Dynamic simulation, Generators are converted as Voltage source with impedance...
Constructing a Short Circuit Equivalent
Network does not converge due to large amount of CLMDBLU2 in system