Ask Your Question

Initial conditions suspects in CMLDBLU2

dynamicsimulation
CMLD
modeling
dyr
retag add tags

Hello everyone, I'm having trouble in figuring out the cause for the following initial conditions suspect.

 INITIAL CONDITIONS SUSPECT:
 I   DSTATE(I)    STATE(I)     MODEL             STATE     BUS#-SCT X-- NAME --X BASKV  ID
  83630   0.69850E-04 -0.68402E-02 CMLDBLU2           K+1     10000     Load 1   12.500  1
  83632   0.59582E-04  0.17921E-02 CMLDBLU2           K+3     10000     Load 1   12.500  1

I want to figure out if this happens due to a model error or due to a voltage issue. Thank You

Erandika

asked 2023-06-13 10:59:50 -0500

edit flag offensive 0 remove flag close merge delete

Comments

add a comment see more comments

1 Answer

Sort by

oldest

newest

most voted

In theory, the DSTATE value should be zero, but in practice, a very small value is workable. I supplement the "initial conditions suspect" table listing with the plotting/evaluation of channels (Pe,Qe,..) after a dynamic simulation under no disturbance for the period of interest (a flatstart for 10 sec.?) An acceptable response would be a flat line with max. deviations smaller than 10e-2. Use PSSPLT to evaluate max. deviations. If the plot has larger deviations or oscillations, model parameters need adjustments.

2.9k

jconto

answered 2023-06-15 09:42:48 -0500

edit flag offensive 0 remove flag delete link

Comments

add a comment see more comments

Initial conditions suspects in CMLDBLU2 edit

Comments

1 Answer

Comments