ilecwv's profile - activity

overview network karma followed questions activity

2020-07-15 12:30:02 -0500	commented question	Where can I find dynamic model WT4E2 block diagram (detailed)? Take a look here https://www.esig.energy/wiki-main-page/%3C/p%3E (https://www.esig.energy/wiki-main-page/)
2020-06-22 11:11:43 -0500	commented question	very helpful research paper for dynamic simulation of wind/solar plant Thank you!
2019-03-18 19:56:50 -0500	answered a question	Model HYGOV Bus 159 [RU-H1 13.800] Machine "1 " : initialized out of limit(s) GMAX Sometimes Pmax in power flow does not match with Pmax in dyr file, so you have to check that Pmax in power flow is equal or lower than Gmax*Mbase
2019-03-18 19:52:50 -0500	commented question	INITIAL CONDITIONS SUSPECT: MODEL GENSAL STATE K Take a look on this... http://psspy.org/psse-help-forum/question/5707/model-hygov-bus-159-ru-h1-13800-machine-1-initialized-out-of-limits-gmax/%3C/p%3E (http://psspy.org/psse-help-forum/question/5707/model-hygov-bus-159-ru-h1-13800-machine-1-initialized-out-of-limits-gmax/)
2019-03-16 10:07:27 -0500	answered a question	INITIAL CONDITIONS SUSPECT: MODEL GENSAL STATE K Just after the command psspy.strt(0,out), usually there is a set of warnings that can give you a clue about what model is giving the problem Something like this... No active table model for Switched Shunt at bus " 3069 [JUT B438 69.000]" -- check this before continuing with the simulation FLOW1 BUS 6487 NOT FOUND--CIRCUIT T1 FROM 6487 TO 6488 Model WT3P1 Bus 3549 [CDH 0.69KV 0.6900] Machine "1 " : When WT operates at partial output, initial condition suspect may be reported for STATE(K+2). No action is needed