Revision history [back]

I am trying to run a simulation with the CMLDBLU1. Just tried a no disturbance test with the CMLDBLU1 at only load bus. The values (voltage, angles, states) are not flat lines. Looking at the log file, the E'q and E''q params of all the 4 motor loads are appearing in the 'INITIAL CONDITIONS SUSPECT". Plotting these states, it is clear that something is going wrong during initialization. The CMLDBLU1 load MVA base was set at -1.

I suspect that somehow the load consumption of the CMLDBLU1 model is not consistent with the PL and QL values of the load in the raw file. I tried to figure this problem out myself and the parameters of CMLDBLU1 relevant to the load consumption could be: Load mva base, the motor loading factors. However, so far, i have not been able to fix this issue.

Anyone has any suggestion regarding this? What CMLDBLU1 parameters should i look at to make sure that the load data in the raw file is consistent with the CMLDBLU1 entry in the dyr file?