Revision history [back]

Hi Everyone,

I am a fresh user of modelling HVDC in PSS/E. I was wondering if my procedures of running the transient stability listed below are correct or not. Are there any additional step(s) required for HVDC LCC\VSC technologies?

1) Add the steady-state DC Line Parameters and steady-state converter parameters of the HVDC lines to my .SAV case

2) Run the load flow

3) Add the transient model parameters including the model of HVDC lines (e.g. CDC4T Model) to my .SAV case

4) Add channels and run the transient simulation as shown in this video:- "www.youtube.com/watch?v=reOFXea8SQk"

Thank you so much!