Revision history [back]

I try running dynamic simulation without any disturbances, it shows steady value until few seconds then suddenly all the parameters drastically increase causing divergence calculation with NaN value. all dynamic models shows no error in DOCU and STRT check so it's hard to tell what the parameter error is, could you suggest some troubleshooting methods?

I am working on a large transmission system with more than 50 generators, I used network data converted from Digsilent. The power flow solution is running seamlessly and shows the exact value with digsilent result, but the dynamic data just not working

I try running dynamic simulation without any disturbances, it shows steady value until few seconds then suddenly all the parameters drastically increase causing divergence calculation with NaN value. all dynamic models shows no error in DOCU and STRT check so it's hard to tell what the parameter error is, could you suggest some troubleshooting methods?

I am working on a large transmission system with more than 50 generators, I used network data converted from Digsilent. The power flow solution is running seamlessly and shows the exact value with digsilent result, but the dynamic data just not workingworking.

I try running dynamic simulation without any disturbances, it shows steady value until for few seconds then suddenly all the parameters drastically increase causing divergence calculation with NaN value. all dynamic models shows no error in DOCU and STRT check so it's hard to tell what the parameter error is, could you suggest some troubleshooting methods?

I am working on a large transmission system with more than 50 generators, I used network data converted from Digsilent. The power flow solution is running seamlessly and shows the exact value with digsilent result, but the dynamic data just not working.

I try running dynamic simulation without any disturbances, it shows steady value for few seconds then suddenly all the parameters drastically increase causing divergence calculation with NaN value. all dynamic models shows no error in DOCU and STRT check so it's hard to tell what the parameter error is, could you suggest some troubleshooting methods?

I am working on a large transmission system with more than 50 generators, I used network data converted from Digsilent. The power flow solution is running seamlessly and shows the exact value with digsilent result, but the dynamic data just not working.