Revision history [back]
Why there are big osicilation in my PSS/E Photovoltaic (PV) project dynamic analysis?
There is very big oscillation when connecting many PVs to the system and do the dynamic analysis.
- All the PV generation I set control mode to +,-Q limits based on WPF. And I set the remote bus in dyr file as 0.
- When no fault applied and more than two PVs are connected to the system, the suspect condition is OK, but the simulation output is not flat as output.
- When I take all PV units and sub network out, the output is flat. The suspect conditions is OK.
- When I only connect one PV to the system and do dynamic analysis, the output is flat and suspect conditions is OK. I hope someone can help me. Thank you！！
Why there are big osicilation in my PSS/E Photovoltaic (PV) PV project dynamic analysis?
There is very big oscillation when connecting many PVs to the system and do the dynamic analysis.
- All the PV generation I set control mode to +,-Q limits based on WPF. And I set the remote bus in dyr file as 0.
- When no fault applied and more than two PVs are connected to the system, the suspect condition is OK, but the simulation output is not flat as output.
- When I take all PV units and sub network out, the output is flat. The suspect conditions is OK.
- When I only connect one PV to the system and do dynamic analysis, the output is flat and suspect conditions is OK. I hope someone can help me. Thank you！！
Why there are big osicilation in my PSS/E PV project dynamic analysis?project?
There is very big oscillation when connecting many PVs to the system and do the dynamic analysis.
- All the PV generation I set control mode to +,-Q limits based on WPF. And I set the remote bus in dyr file as 0.
- When no fault applied and more than two PVs are connected to the system, the suspect condition is OK, but the simulation output is not flat as output.
- When I take all PV units and sub network out, the output is flat. The suspect conditions is OK.
- When I only connect one PV to the system and do dynamic analysis, the output is flat and suspect conditions is OK. I hope someone can help me. Thank you！！