Original IEEE 14-bus network has 3 synchronous condensers. I want to run the simulation without including them. When I switched off two of them and all three the simulation crashes and no transient stability analysis has been performed. Anyone can explain why this is so happens.
The condensers supply inertia and short circuit power during the simulation. Obviously, the system becomes unstable without them.
Perform a simulation with the condensers and plot P & Q to see their support to the system.
Okay fine. But I think this situation should occur when all the condensers are off. I have closed two small rating condensers and open one high rating condenser but the system still shows same problem.
Asked: 2022-09-25 06:12:35 -0500
Seen: 351 times
Last updated: Sep 26 '22
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
