I have a simple SMIB case of an aggregated solar plant modeled in PSSE. Could anyone let me know how to simulate a phase angle jump test at the Point of Interconnection. Usually with the playback model only voltage and frequency signals can be played back in but I am not sure how to simulate a phase angle jump test. Any suggestions are appreciated
I would suggest the same! using a a PST is the solution! this way you will ensure that the phase angle is shifted as is required to and your PLBVFU1 can have you desired profile. Good luck!
You can have two transmission lines between infinite bus and POI. Simulate trip of one branch. The new load flow will change the bus angle at POI.
Do not use playback model in this simulation, use GENCLS instead.
EDIT:
A better alternative is to have a transformer between infinite bus and POI. Change the transformer phase shift during simulation to emulate a voltage angle phase shift. In this way you can select the wanted angle shift, e.g. 5 deg, 10 deg , 15 deg etc.
Asked: 2022-07-01 21:11:05 -0500
Seen: 472 times
Last updated: Jul 21
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
