Hello, im trying to simulate a large disturbance (loss of large synchronous generators) and after 3-4 seconds into the simulation, the NaN errors show up in the log. Any advice? i have reduced timestep etc.. Case is fine with the CLODBLU model..
Model CMLDBLU2 is very advanced with 133 CONs!!!
Have you monitored the bus voltage? Does it go low or high before crash?
Have you monitored the STATES and VARS of the model to see where it goes berserk?
i found the issue and resolved it. its due to CMLDBLU2 model itself.
Asked: Mar 22 '2
Seen: 220 times
Last updated: Mar 23 '22
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
