hi guys,
Im new for psse34,and i want to do some simulation for fault data.But everytimes simulation finished,I only get ET,EFD, P,Q,ANG.So i need some help that how to get three-phase data ,just as A,B and C phase current and voltage.
Its very important for me,plz help me,thank u all!
In PSSE only the positive sequence system is modelled in dynamic simulations. It is therefore not possible to plot phase voltages and currents in a dynamic simulation.
Then unbalanced faults are simulationed in PSSE, only the effect on the positive sequence voltages and currents is simulated. Negative and zero sequence is omitted and it is not possible to plot the phase quantities.
Asked: 2021-03-11 07:26:58 -0500
Seen: 364 times
Last updated: Mar 15 '21
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
