Hey, I don't know if I am being totally stupid here but for some reason when I try to use the PLBVFU1 inside of my script (by simply running a blank dynamic run) I do not get the desired effect, however when I run the same model inside PSSE V34 itself with the same .plb and dyr file I get the expected result. Is it possible to do with the location of the .plb file ? Not sure, any tips would be appreciated.
When using PSSe GUI ('inside' mode) the working folder is set when you load the case and the plb file location should be on it. In a script (outside the PSSe GUI), the working folder (containing the sav and plb files) could be set explicitly in the code or by default, is set to the folder from where it was launched. Exa.:
savpath = c:\\abc\\cases
os.chdir(savpath) # change working dir to find *.plb file
psspy.case('mycase.sav') # located at savpath
Thanks Jconto, found this out yesterday by fiddling and didn't get a chance to reply to my own question. Do you have some example of how to set it in code by any chance, or somewhere where there is information about how the PLBVFU1 model functions. I had a look at your google drive link about this _
_ and was unable to make heads or tails about this. Cheers
Asked: 2018-06-20 20:52:02 -0500
Seen: 1,770 times
Last updated: Jun 23 '18
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
