Would anyone be able to describe what my PSSE RAW and SEQ motor model should look like when I perform dynamics using a CIM5BL motor model? Should I be entering "machine" data or "load" data in the network data section? The instructions in the PSSE manual is not as straight forward.
Many thanks in advance
The CIM5 load model is discussed in the PSSe "Models.pdf" manual, pg. 9-9
I have prepared a python code to execute a dynamic simulation on the savnw.sav/savnw.dyr files located in the example folder of the PSSe v.33 installation. To assign the CIM5BL model to loads located at bus 154, add the following data to the end of the savnw.dyr file and save it:
@! cim5 load model
@! M, RA, XA, Xm, R1, X1, R2, X2, E1, S(E1), E2, S(E2), MBASE,PMULT, H, VI, TI, TB, D, Tnom
154, 'CIM5BL', '*', 2, 0.053, 0.076, 2.4, 0.048, 0.062, 0.0, 0.0, 1.0, 0.06, 1.2, 0.6, 0.0, 1.2, 0.28, 0.0, 0.0, 0.0, 1.0, 0.0, / m1
Download the runsim.py code [copy the link into your browser if it does not connect when clicking on it]:JConto_google drive. Once you select “runsim.py”, an icon on the top-center screen will perform the download.
Make sure you can run it in your PC and then later, modify it to fit your run. Study the log file to check that there is no error produced by the PSSe activitites (python commands). If needed, set the integration step size to 0.001 (and matching freq. parameter to 0.004) to help with NAN output and not convergence issues.
Thanks JConto for your reply. As for following your example, my question still pertains setting up the data for the load at bus 154. In the sample savnw.sav file that I have for PSSE v33, there is no load in the network data. My question is how do I setup that load in the savnw.sav file. Many thanks
Thanks JConto, I was trying to understand the parameters for CIM5BL and am not to clear on Tnom. Is it necessary to derive a value for it or can I just use 0. Tnom seems to affect the duration in which the voltage recovers when the motor reaches full speed. Any advice helps. Many thanks.
Hi there, Can you help me here? I understand I have to add the above sample parameter set to the dyr file(for example a cim5bl model to 154 bus). How about in my .sav file? There is no load here. It seems like there is dynamic characteristics of load which is not there. What modification in .sav ?
Asked: 2017-07-13 23:54:58 -0600
Seen: 1,216 times
Last updated: May 12 '20
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
If I use model CIM5BL for motor what about VFD ? Thank you ?