Ask Your Question
0

PSSE 33.9 vs 33.10 Dynamics Simulation Results Mismatch

Hi,

I recently installed the latest PSSE 33.10 version. I previously was using 33.9 version. I found when I run the exact same dynamic simulation in each version the results are significantly different, with the 33.10 results going unstable and crashing the program but the simulations run fine in 33.9 and show no instability.

I am using the exact same cases, dyr data, same faults, clearing times, etc. I reviewed the release notes for 33.10 and none of the things I am using appeared to be affected by the updates in 33.10.

Is anyone else using PSSE version 33.10 for dynamics simulations and seen anything like this? I am wary that it is still an issue on my end that I haven't discovered but I thought it would be good to see if anyone else has seen this issue before I investigate further.

I would attach some sample plots of the dynamic results from both versions but I do not have the required points to do so.

oppossumX's avatar
50
oppossumX
asked 2017-07-05 19:40:03 -0500
edit flag offensive 0 remove flag close merge delete

Comments

add a comment see more comments

1 Answer

0

I am using v.33.10 for dynamics and found no problems after moving from v.33.9. Try to compare the log files of both runs, to find out were they began to differ. if you have UDM in obj format, the dsusr.dll would require to be re-compiled. If there are steady state activities before running dynamics (like re-dispatching), make sure that the load flow settings (capacitor switching on, etc.) are the same for both versions.

jconto's avatar
2.9k
jconto
answered 2017-07-05 19:58:56 -0500
edit flag offensive 0 remove flag delete link
more

Comments

Thanks. It is good to know that 33.10 is working and this is most likely a problem on my end. I will look into my simulation settings further.

oppossumX's avatar oppossumX (2017-07-06 12:37:32 -0500) edit
more
  • delete
add a comment see more comments

Your Answer

Login/Signup to Answer