I am trying to do consecutive SCMU calls with upstream branches switched out. SCMU/1 does an SEQD each time if sequence network setup option is set to 1. BUT when i try to do sequencenetworksetup(1) i get told that the name is not defined. As this is meant to be part of the PSSE API, how can this not be defined? Am I missing something?
Hope someone can help.
To answer the comment, yes, I had included the underscores.
After doing a little further reading, I find that when using python with PSSE, the straight up API call won't work, it sometimes needs psspy at the start.
So
psspy.sequence_network_setup(1)
works as intended.
Now my code works. Just in case anyone else is looking, the code is designed to fault a bus, then remove transformers and branches from service one at a time and fault the bus with a branch off to see the change in fault level.
My coding is rarely elegant, but it is generally effective, so if anyone else is looking to do similar, I might be able to help.
Asked: 2014-08-26 20:09:16 -0500
Seen: 356 times
Last updated: Aug 27 '14
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
