No active table model for in-service machine
I am trying to run a dynamic simulation using generic renewable models for a SMIB case. There are two generators connected to the same bus. However, when I initiate only one machine was correctly initiated and always the other machine gives me "No active table model for in-service machine" message. I checked dyr file for any inconsistencies but couldn't spot any issues. When I opened the dyr file in GUI, I can see both machines have their dynamic models correctly attached. I am using REGCA1, REECA1, WTDTA1, WTPTA1, WTARA1, WTTQA1 and REPCTA1 models. Are there any solution to this issue or am I doing something incorrectlry here? Following is the dyr entry for non operating machine.
11 'REPCTA1' 1
104 104 1 '1 ' 0 0 0
0.02 18.0000 5.00 0.0000 0.0000
0.9000 0.0000 0.0000 0.90000E-01 10.000
-10.000 0.0000 0.0000 0.330 -0.330
0.60000 1.2000 0.60000E-02 -0.0006 0.0006
0.900 -0.90 1.10000 0.1000 0.01000
20.000 20.000 /
When I use a saved case after converting generators and loads, this issue resolved. Still don't know this is the correct way.
You should always convert case before doing simulation. Not sure why you got "No active table model for in-service machine" instead of giving you error regarding not using converted case.