Revision history [back]

The calculation of FVSI is based on steady state network conditions. The case after a dynamic simulation cannot be used for steady state activities. There is a need to 'de-convert' a dynamic case before using steady state PSSe activiteis.

For your study, you have to 'de-convert' the case at the end of the dynamic simulation before the FVSI calculation.

To de-converter a dynamic case:

1- From the steady state case used to run the dynamic simulation, take note of the swing bus (type 3)

2- At the end of the dynamic simulation, save the case as RAW file.

3 - Edit the RAW to change the bus type of the swing bus using data in (1)

4- Load the modified RAW file. Solve it. (Save it as *.SAV)

5- Case is ready for steady state activites.

The calculation of FVSI is based on steady state network conditions. The case after a dynamic simulation cannot be used for steady state activities. There is a need to 'de-convert' a dynamic case before using steady state PSSe activiteis.activities.

For your study, you have to 'de-convert' the case at the end of the dynamic simulation before the FVSI calculation.

To de-converter a dynamic case:

1- From the steady state case used to run the dynamic simulation, take note of the swing bus (type 3)

2- At the end of the dynamic simulation, save the case as RAW file.

3 - Edit the RAW to change the bus type of the swing bus using data in (1)

4- Load the modified RAW file. Solve it. (Save it as *.SAV)

5- Case is ready for steady state activites.activities.

The calculation of FVSI is based on steady state network conditions. The case after a dynamic simulation cannot be used for steady state activities. There is a need to 'de-convert' a dynamic case before using steady state PSSe activities.

For your study, you have to 'de-convert' the case at the end of the dynamic simulation before the FVSI calculation.

To de-converter a dynamic case:

1- From the steady state case used to run the dynamic simulation, take note of the swing bus (type 3)

2- At the end of the dynamic simulation, save the case as RAW file.

3 - Edit the RAW to change the bus type of the swing bus using data in (1)

4- Load the modified RAW file. Solve it. (Save it as *.SAV)

5- Case is ready for steady state activities.