Revision history [back]
 | 1 | initial version |
how to ger sequence data with (.raw and .dyr) use psse
Dear guys,
1.when there is only the .raw and .dyr files, how to get the sequence data? for example the savnw.raw and the savnw.dyr of the PSSe example.
dynamic stability analysis how to output the short circuit current during the dynamic simulaiton? use the .raw and .dyr of the case I built to do the dynamic simulation. and apply the bus fault for severl cycles then clear the fault. then I want to get the short circuit current during the dynamic process. but I could not see the short current or the current channel on the "Channel Setup Wizard",there are only Angle,Pele… .
steady state analysis use the IEC module and KBDY on PSSe GUI.
What do you think about it. Is that right? Could you tell me how to do this on PSSe and give me a video(or make a .py or .idv file to me )?
| | 2 | No.2 Revision |
how to ger sequence data with (.raw and .dyr) use psse
Dear guys,
1.when there is only the .raw and .dyr files, how to get the sequence data? for example the savnw.raw and the savnw.dyr of the PSSe example.
dynamic stability analysis how to output the short circuit current during the dynamic simulaiton? use the .raw and .dyr of the case I built to do the dynamic simulation. and apply the bus fault for severl cycles then clear the fault. then I want to get the short circuit current during the dynamic process. but I could not see the short current or the current channel on the "Channel Setup Wizard",there are only Angle,Pele… .
steady state analysis use the IEC module and KBDY on PSSe GUI.
What do you think about it. Is that right? Could you tell me how to do this on PSSe and give me a video(or make a .py or .idv file to me )?
