Bikash's profile - activity

Thank you for the response. I can change the value of VAR using this command but I want to link another variable to feed the signal every time during dynamic simulation. I want to set the controller to vary the power output of battery according to requirement.

I am trying to use CBEST battery generation model and need to control the Paux VAR based on the frequency of connected bus. From the documentation of PSSE, I found that that sort of linking can be done using CONET and CONEC subroutine. However, I couldn't figure out the next steps after addition of the codes to the created CONET and CONEC subroutines. I am pretty new to the model writing and have never done it before.

Hello everyone,

I am trying to add 40 unit 1.5 MW each type-4 wind farm equivalent in my 9-bus case system. Everytime there is some disturbance, I am getting continuous frequency spikes( 5-7 second intervals) in the system for rest of the dynamic simulation. Without the disturbance the system runs smoothly. Is there anything important I should consider while modeling to avoid those spikes?

Thank you..... it worked.

Hello,

I am having trouble with the PSSE 34 EXplore(free version) . It crashes everytime I try to do something new or try to use files from other version of PSSE. Does anyone have the same kind of problem or is it just me?

Hello there!! I am new to PSSE. After I perform the dynamic simulation is there any way to reset the datas to initial condition of prior to the simulation.