Revision history [back]

How can I check for voltage violations using ACCC?

The range violations shown in the results of the ACCC study are based on the ranges which are specified in my .mon file, which I in fact do not care about, but have to choose something because of the format. I have specific Vmax and Vmin values for each bus, which are described in my case file.

Is there any simple way to get the voltages which violate these ranges to show up in some tabulated form? Or do I need to adjust my .mon file so that it reflects the data in my case file?

I am not quite sure what the "Use Emergency Voltage Limit" box is supposed to be used for in the AC contingency if that information is not included in the .acc results file ...