Revision history [back]

Wind PP modeling

I have parameteres like: -LFSM(-U,-O) droop=5% - Ramp rate down (110 MW/min), up (6 MW/min) - Voltage regulation: order delay (0,1 sec), time to achieve 90% of the achieved Q (0,27 sec), droop (2%), insensitivity (0). As I am using aggregated model I dont need to have plant control. So, how to connect those parameters with models like REGCA1, REECA1?

Wind PP modeling

I have parameteres like:

-LFSM(-U,-O) droop=5% - Ramp rate down (110 MW/min), up (6 MW/min) - Voltage regulation: order delay (0,1 sec), time to achieve 90% of the achieved Q (0,27 sec), droop (2%), insensitivity ~~(0).~~ (0).

As I am using aggregated model and REGCA1, REECA1. Should I ~~dont need to have~~ add plant ~~control. So,~~ control model and how to connect those parameters with ~~models like REGCA1, REECA1?~~models?