ZIP model for compressor motor

asked 2023-04-16 16:12:40 -0500

psse_user_88
19 ●7 ●8 ●12

Hello,

I would like to model in one of the buses in my study case, a very large electrical compressor motor of 10MW. Can I use the ZIP model for modelling of this motor as load for dynamic simulation. I will oberserve the voltage drop in case of short circuit in nearby nodes and frequency drop?

Any advice if this is enough accurate? I am thinking of this because using the CIM5BL or other induction motor models would need a lot of parameters which I don't have.

Thank you

answered 2023-04-17 02:35:43 -0500

perolofl

3312 ●1 ●8 ●18

I would recommend to use CIMBL5 with typical data for a large motor, see Figure 21-1 in Program Application Guide Volume 2.

edit flag offensive delete link

Comments

Thank you Perolofl, could you provide some typical model data, I am trying with some data but the model is not converging after adding CIM5BL dynamic load in PSS/E.

psse_user_88 ( 2023-04-17 06:03:03 -0500 )edit

Have you reduced the time step. Try with 1 ms!

perolofl ( 2023-04-17 12:01:26 -0500 )edit

Thank you Perolofl. It worked by reducing the DELT value to 1ms.

psse_user_88 ( 2023-04-18 04:25:06 -0500 )edit

I tried using CIM5BL with the following parameters : 154 'CIM5BL' 1 1 0.0048, 0.0744, 2, 0.0163, 0.0814, 0.0043, 0.0470, 0, 0, 0, 0, 8.8680, 0, 2.3960, 0.2, 12, 4, 2, 0.35/ and added the model to savnw.sav at node 154.

psse_user_88 ( 2023-04-18 04:33:58 -0500 )edit

add a comment

ZIP model for compressor motor

1 answer

Comments

Your Answer

Question Tools

Stats

Related questions