Hi everyone, I have a problem with dynamic function simulation in PSSE 33. After I set the model parameters (Generator, Exciter, Governor) for the Machine and Wind machine. INITIAL CONDITIONS CHECK O.K. but I can't click the button RUN in the tab Perform dynamic simulation (button RUN doesn't light up - attach picture). I am ongoing work on my master's thesis. Please help me if you can. Thank you for paying attention.
Before running dynamics there are steps needed to "get ready":
- is case converging?
- convert loads from P, Q constant to ZIP model
- convert generators from Thevening to Norton equivalents
- solve with TYSL
- read dynamic models
- read UDM in dll format, if any
- set channels to monitor
- set machine angle reference, dynamic parameters...
- initialize the dynamic run, check in the log that models were NOT disabled.
More information -> Search this forum for "dynamics". A post "Dynamic simulations using Python" shows an example of using python code to perform a dynamic simulation.
Asked: 2023-02-23 08:35:26 -0600
Seen: 332 times
Last updated: Feb 23 '23
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.