Model data contains warnings and/or errors message while adding dynamic model details. I am using IEEE 24 bus system and is using .dyr file provided by jconto on his google drive. i am not being able to add the link or picture here. but the few of the details are highlighted yellow which is causing error
I reposted the data set "IEEE24jconto" at my public google site, no major changes. This setup uses idvs, no python. The log file describes the process to achieve a good "flat-start", all variables respond with flat lines under no disturbance. To prepare the base case, study the PSSe commands in file MakeCnv.idv. To create a snap file, study the contents of MakeSnp.idv. At the initialization, there is no suspect conditions, where the log shows "INITIAL CONDITIONS CHECK O.K." The "ieee24_readme.txt" file describe how to run the whole process at once using the batch file "ieee24flat.bat" within a DOS window (use the link "PSSE XX Command Prompt")
Asked: 2021-10-08 06:10:54 -0500
Seen: 384 times
Last updated: Oct 08 '21
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
Can you initialise without getting initial conditions suspect?
I didn't get you. I am not using python.
I am not talking about python. Have you initialised a dynamic simulation in PSSE?