First time here? We are a friendly community of Power Systems Engineers. Check out the FAQ!
At the end of the dynamic simulation, can i just save all that info it into a .sav file? Or is it more complicated than that?
You can save the case at any time when performing a dynamic simulation. Just remember to use a new file name so you don’t destroy the original saved case.
This temporary case cannot be used as a start of a new simulation, i.e. don’t initialise a new simulation from that case.
Thanks! Just one more question. It seems that any loads which have a motor model attached to them show zero values for load demand. Is there any quick way to get the motor load consumption?
Try to enter load channels for motor load and save a temporary snapshot after simulation.
Asked: May 19 '1
Seen: 602 times
Last updated: May 19 '21
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
