0

GGOV1model

asked 2021-03-09 05:07:29 -0600

rahmed
1 ●5 ●6 ●5

I simulate with PSSE a production group loss using a GGOV1 regulator. At first the regulator responds well. So the mechanical power increases to correct the drop in frequency. But when the frequency reaches 49.8Hz the mechanical power begins to drop which is wrong because the setpoint frequency is 50Hz. I can't figure out why this drop and what should I do to correct it.

edit retag flag offensive close merge delete

1 answer

Sort by » oldest newest most voted

0

answered 2021-03-09 11:02:59 -0600

3332 ●1 ●8 ●19

In power systems droop control is used for primary frequency control of the generator. This means that the governor is not supposed to bring the frequency back to 50 Hz after a disturbance, e.g. trip of a unit.

After the generation loss the mechanical power is settling at a new operating point based on its droop setting. The frequency droop is defined in CON(J) of the model. The behaviour of your model seems very normal.

edit flag offensive delete link

Comments

Thank you for your answering. But why other models, such as GAST, don't have the same behaviour as the model GGOV1. In fact, the mechanical power of the GAST increases to correct the drop in frequency and remains constant with the new operating point.

rahmed ( 2021-03-12 04:26:03 -0600 )edit

Model GGOV1 should also remain constant at a new operating point. Have you simulated until steady a new state is reached?

perolofl ( 2021-03-15 05:28:26 -0600 )edit

Yes, I did

rahmed ( 2021-03-17 04:19:37 -0600 )edit

And the new Pmech is above the initial value? I assume you got a new steady operating point.

perolofl ( 2021-03-17 11:12:11 -0600 )edit

Thank you again for your answer. I don't understand why the drop in Pmech, at a frequency value of 49.75Hz and not 49.9Hz for example.

rahmed ( 2021-03-18 07:36:24 -0600 )edit

see more comments

Question Tools

Stats

Asked: 2021-03-09 05:07:29 -0600

Seen: 577 times

Last updated: Mar 09 '21

whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.

Powered by Askbot version 0.7.55