slider printing

asked 2020-03-05 10:31:27 -0600

jmenke04
1 ●1 ●1 ●2

updated 2020-03-05 10:56:00 -0600

I am having issues when printing sliders. An example is that I have a case file for 2020, 2025, and 2030. I have 5 sliders a piece of each of these, representing different sections of the case file (NE, NW, SE, SW,WC). All of the 2020 files print to pdf fine. It is the 2025 and 2030 sliders that I'm struggling with. I can load the 2025 case file fine, print every section fine except for NE and its the same with the 2030 sliders. The NE section prints as a small rectangle. When I look at the saved pdf file, I have to zoom in 6000% to actually start seeing some of the slider diagram. I can not figure out why the 2020 NE slider prints fine, or that the other slider sections of 2025 and 2030 print fine but its just those 2 that I'm struggling with.

I am using PSS/E 34. This obviously is a scaling issue but I can not find how to change it, or why only those 2 out of the 15 would be different.

Any help would be greatly appreciated!