I build a SMIB to do the dynamic simulation.
During the simulation, I need to apply a Voltage dip(from 1PU to 0.7PU) at 2s for the point of connection (for example bus 4).
If I don't use the playback model, how can I implement the Voltage dip? Is it possibel to apply the Bus Fault? Thank you very much.
Calculate the three phase short circuit power at bus 4 with ASCC.
Simulate a bus fault and use the following fault admittance in MVA: B = dV * Sc.
If the short circuit power is 5000 MVA and the voltage drop is 0.3 pu (1pu-0.7pu) the fault admittance becomes 0.3 * 5000 = 1500 MVA. The following fault is applied:
This will roughly result in the wanted voltage dip to 0.7 pu. If needed, you can fine tune the fault admittance in order to come closer to 0.7 pu voltage.
Asked: 2019-10-09 03:05:40 -0500
Seen: 1,615 times
Last updated: Oct 10 '19
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
