Hello
I only have the PSS/E Explor V34. So I can't use playback model. I was told it is possible to use GENCLS & SEXS model to build the SMIB to do the frequency & voltage response test? Is it correct? Does anyone know know how to do these or any helpful document? Thank you very much.
If you don’t want to use the playback model, you can still run voltage response test by write a UDM exciter model to set Efd based on the specific voltage curve that you want to achieve. Or you modify Efd in conec. The easiest way is to use playback.
I think, for voltage response test, you can use an ideal transformer at the point of interest and change the taps after each pause in dynamic simulation. This would effectively change the voltage at the point of interest.
Asked: 2019-09-24 15:22:24 -0500
Seen: 2,468 times
Last updated: Nov 19 '19
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
