First time here? We are a friendly community of Power Systems Engineers. Check out the FAQ!
Hi everyone,
How to solve this initial conditions suspect??
INITIAL CONDITIONS SUSPECT:
I DSTATE(I) STATE(I) MODEL STATE BUS# X-- NAME --X BASKV ID
3387 -1.3916 1.0554 GENSAL K 25 MACHINEG1 13.800 1Beforehand thank you very much
Just after the command psspy.strt(0,out), usually there is a set of warnings that can give you a clue about what model is giving the problem
Something like this...
No active table model for Switched Shunt at bus " 3069 [JUT B438 69.000]" -- check this before continuing with the simulation FLOW1 BUS 6487 NOT FOUND--CIRCUIT T1 FROM 6487 TO 6488
Model WT3P1 Bus 3549 [CDH 0.69KV 0.6900] Machine "1 " : When WT operates at partial output, initial condition suspect may be reported for STATE(K+2). No action is needed
There could be any number of reasons for this. It is almost impossible for anyone to diagnose this problem without seeing the PSS/E files that caused the problem (SAV, DYR etc.)
Asked: Mar 15 '19
Seen: 1,434 times
Last updated: Mar 18 '19
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
Take a look on this... http://psspy.org/psse-help-forum/question/5707/model-hygov-bus-159-ru-h1-13800-machine-1-initialized-out-of-limits-gmax/%3C/p%3E (http://psspy.org/psse-help-forum/question/5707/model-hygov-bus-159-ru-h1-13800-machine-1-initialized-out-of-limits-gmax/)