I'm trying to figure out how I can clear only the island that the tripping element is causing during the tripping of the fault element right after distclearfault().
When I use psspy.tree(1,0) and psspy.tree(2,1), it clears ALL islands within the case which I do not want.
Activity TREE is a load flow function. It cannot be used in dynamics since there is no swing bus after generator conversion.
Normally you can run the simulation without clearing the "island" manually. PSS/E will automatically trip the island if there is no generator in it.
Asked: 2016-11-22 12:29:39 -0600
Seen: 989 times
Last updated: Nov 22 '16
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
