I am trying to observe effect of wind speed variation on power generation by wind generator (DFIG), but after changing speed by huge amount, there is very negligible variation in power generation. I am changing value of initial wind speed during simulation to change wind speed. Is it the correct way?
I think this is not a right way to change the initial wind in order to alter the wind speed in dynamic simulation. The initial values are calculated through the power flow results. And in PSS/E there is no wind model in general model library. You should defined it by yourself.
Asked: 2015-11-05 06:06:03 -0500
Seen: 918 times
Last updated: Jul 25 '16
whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
