First time here? We are a friendly community of Power Systems Engineers. Check out the FAQ!

How to cause a three-phase short circuit in the middle of the line

学术弟中帝
1 ●8 ●9 ●9

How to cause a three-phase short circuit in the middle of the line？

Comments

Run the SCMU activity. Other way is tap the line in the middle and use ACCC activity.

jbarberia (Mar 13 '5)

Sort by » oldest newest most voted

dat
11 ●8 ●10 ●12

你是要做线路上的三相短路故障吗？暂态仿真先Run到你想让故障开始的时候，然后在Disturbance里选Line fault，就可以设置发生故障的线路和故障阻抗的大小了。

It is better to write in English in this forum!

perolofl (Mar 14 '5)

3452 ●1 ●9 ●20

For in-line fault in a dynamic simulation, see post how can i set the fualt location in PSS/E.

1 follower

Asked: Mar 13 '5

Seen: 92 times

Last updated: Mar 14

whit loves you. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.