Revision history [back]

Hi I work with the 34th version of this software and on the 39 Bus system (referred to on this site). All the simulation steps are done without error. And the output of the voltage waveform is also acceptable (during the fault). And .dyr file Also, it was tested in the presence of a generator, Excitation,Turbine-Governor and load a model with and without them. But the problem is that by applying any error in the system (each fault line for 80 ms), the voltage range does not change from 0.95 to 1.05 and is stable! The question is, is there any setting that makes this a limitation? What can be connected to? Thank you