Revision history [back]

Its very easy to run dynamic simulation using GUI only. Just load .sav and .dyr files then go to dynamic tab and add channels...(basically quantities to observe)... In same tab go to perform simulation. Provide out put file name to store plots. Select plotting requirements. Initialize first. Then Run the simulation to specific time you need. You can apply disturbances also after time you wish. Continue simulation. Take a new plotbook from file tab. add plots as many as you want , may be on different pages. Open .out file . On left there is Project Tree View ....Go to channels in that... then drag required channels on plots selected. There you go.